nww1969
8th Jan 2012, 09:36 PM
Next project for next weekend and need some suggestions once again please.
Have small outdoor patio area half exposed to the elements ,some of the tiles have come loose towards the end.
Current set up is the tiles are just square set with the face over a concrete base which has a rubber?? water membrane
which I can just lift some of the edge tiles up with the cement adhesive still stuck to the tiles and has exposed which
looks and feels like a rubber membrane, the area is very wet underneath and I suspect could be under all the other tiles but they seem solid.
I have just cut a 60mm section off part of the edge of the missing and what is left of the edge tile to fit some step treads
which I have done as some of the loose tiles had pieces chipped. So some suggestions on what I should be using for
adhesion to the membrane.??
Thanks in advance.
Have small outdoor patio area half exposed to the elements ,some of the tiles have come loose towards the end.
Current set up is the tiles are just square set with the face over a concrete base which has a rubber?? water membrane
which I can just lift some of the edge tiles up with the cement adhesive still stuck to the tiles and has exposed which
looks and feels like a rubber membrane, the area is very wet underneath and I suspect could be under all the other tiles but they seem solid.
I have just cut a 60mm section off part of the edge of the missing and what is left of the edge tile to fit some step treads
which I have done as some of the loose tiles had pieces chipped. So some suggestions on what I should be using for
adhesion to the membrane.??
Thanks in advance.