20344
Australia's largest renovations forum

Get the best decking and save up to 40%

Go

floating deck/pontoon

Results 1 to 8 of 8
  1. #1
    Novice helga's Avatar
    Join Date
    Jul 2005
    Location
    alstonville
    Posts
    37

    Smile floating deck/pontoon

    I am fantasising about summer already, and we have hatched a plan to build a pontoon to moor to the side of our dam so you don't have to walk through the muddy edge when getting in and out of the water. Has anybody built one or seen a plan of one? We have some pickle barrels but I'm not sure if they will float too proud of the water and be unstable. Any suggestions gratefully received. Thanks, Helga

  2. #2
    Novice Dion N's Avatar
    Join Date
    Oct 2003
    Location
    Gold Coast
    Posts
    29

    Default

    How much weight will the pontoon have to bear?

    To design the pontoon

    1. calculate the volume of the pontoon (this lets you know how much water is displaced by the pontoon). For every 1000 cm3, the pontoon displaces 1 litre of water.

    2. The displacement in litres = the weight the pontoon can take in kg. For safety, only load to 90%.

    Example - say your barrel has a height of 80 cm and a diameter of 40cm (ie a radius of 20cm)

    Volume of a cylinder = pi X radius squared X height
    = 3.14 X 20 x 20 x 80 = 100,480cm3

    Divide by 1000 to get litres = 100.48 litres

    Therefore, your barrel could support a maximum of 100 kgs, although 90kg would be a safer limit.
    "If something is really worth doing, it is worth doing badly." - GK Chesterton

  3. #3
    Adelaide Hillbilly kiwigeo's Avatar
    Join Date
    Jul 2004
    Location
    Adelaide Hills
    Age
    56
    Posts
    89

    Default

    Quote Originally Posted by helga
    We have some pickle barrels but I'm not sure if they will float too proud of the water and be unstable. Any suggestions gratefully received. Thanks, Helga
    This project requires very careful planning. Step 1 is to aquire a half a dozen barrels brim full of fine malt whiskey. Step 2 is to empty the barrels (preferably not in one session) while you carefully develop a plan for the mighty pontoon project. By the time youve got through all that whiskey youll have a very carefully thought out plan and six empty barrels.
    Whatever note you blow youre never more than a semitone away from the correct one....(Miles Davis)

  4. #4
    Novice helga's Avatar
    Join Date
    Jul 2005
    Location
    alstonville
    Posts
    37

    Smile

    Thanks for suggestions dion and kiwigeo.the pickle barrels we get held pickled onions and gherkins. I don't think I could eat my way through 1200L of gherkins. I'm feeling sick just thinking about it! Luckily we get them empty. I'm guessing 3 people and the timber for the deck of it would be the weight load. I will see what the demolition yard has in the way of ladders. I'm just not sure if I should tether it to the bank or anchor it to the dam floor or both!?helga

  5. #5
    Apprentice (new member)
    Join Date
    Jun 2005
    Location
    -28.680409 / 153.360896
    Posts
    4

    Default

    helga,
    what we did -
    4x 200 L plastic drums from mountain chemicals in Lismore (ex detergent of some sort). They have 2 screw in bungs rather than lids.

    Built a treated pine deck, over a frame that sits on the drums (lying on their side at each corner). Drums end up under the frame so you don't have to look at 4 big blue things... Frame was about third of the way down the drum so they don't go anywhere, but the frame stays clear of the water. Frame wasn't fixed to the drums, so if one gets a leak, drum just drops to the bottom of the dam.
    Put drums in pond. Dropped deck and frame over drums. Sat 4 people on deck and loosened bungs to let water in until the whole thing sat at a nice height in the water. Worked around the 4 progressively to get it level. If you get it so that one bung is above water level, and one below, you can adjust the floating height by loosening bottom bung, then top bung - lets in water, close top bung and use a foot pump to pump air in bottom bung to raise etc

    Attached floating deck to shore with a walkway long enough to deal with low dam level - galv gate hinges between deck and walkway, couple of those concrete house stump pads on shore with more galv hinges, so it adjusts to changes in water level.

    Very popular with ducks and snakes.......

    -r

  6. #6
    Therapeutic woodworker
    Join Date
    Jun 2005
    Location
    rural Sydney
    Age
    66
    Posts
    10

    Default

    Helga,
    I did something like rhack but used a larger number of 20l plastic drums, the squareish type used for pool chlorine. They have a screw cap and a small bung where one can screw in a tap. I had them lying on their side under the treated pine decking and had the screw cap at the top and the small hole at the bottom with the bung out. Adjusted the floating depth by loosening the cap and letting air out as required etc. More fuss getting it even with a larger number of drums, but you only have to do it once. No need to plug the bottom hole - if the air can't get out the top then the water won't go in.

    The partially filled drums give the pontoon a lot of stability. A pontoon with empty drums rides high and is very lively to walk around on.

    Buy a good garden broom as you will need it for regular duck poo cleaning. Our snakes are much tidier and only red belly blacks, well the browns do visit but don't lie there sunning themseleves like the blacks.

    cheers
    Dr Dee
    Trying to work less and machine my time away

  7. #7
    Novice helga's Avatar
    Join Date
    Jul 2005
    Location
    alstonville
    Posts
    37

    Smile

    thanks guys

    sounds like a lot of bunging about in the dam, will definitely have to wait for warmer weather, but at least now I know what parts to assemble. We also have yellow faced whip snakes, bandy bandy and carpet snake as well as red bellied blacks. I've only seen one brown here and it was a baby. I always think "where's mum?" when I see a baby snake.

  8. #8
    Senior Member Markw's Avatar
    Join Date
    Jul 2003
    Location
    Mt Druitt NSW
    Posts
    177

    Default

    If you want something that would best belong up the crick in the Beverly Hillbilly's then use the drums.

    or

    get a proffessional pontoon of the type used to moor small boats along side.

    I used to help install these types of jetties for the mega rich in Sydney Harbour a few years ago using pacific marinas products. Dont know if they're still available but looked something like this only generally smaller

    http://www.thejettyspecialist.com.au/domjet/index.html

    The moving decking shown is steel with a timber top and the peiring is concrete where as we used turp piles and all jarah decking with gal pin hinges. Worked OK in Sydney during heavy winds/seas
    ______________
    Mark
    They only call it a rort if they're not in on it

Similar Threads

  1. Replies: 1
    Last Post: 29th Oct 2007, 10:30 AM
  2. Replies: 2
    Last Post: 21st Sep 2007, 09:31 AM
  3. Floating floor
    By Eddie Jones in forum Flooring
    Replies: 9
    Last Post: 21st May 2006, 08:09 AM
  4. Floating Floor
    By micklejohn in forum Flooring
    Replies: 10
    Last Post: 1st Jun 2005, 09:53 PM
  5. Floating floors
    By FrankS in forum Flooring
    Replies: 3
    Last Post: 13th May 2005, 03:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •